Version 1.4, July 2024 Configure and Operate Load Control Devices 1 Configure and Operate Load Control Devices — Application Note This application note describes how to configure load control devices and the available operating modes for your customers. Revision history Version 1.4, July 2024: Updated SolarEdge Home Network devices compatibility Version 1.3, February 2024: Latest Firmware version…
Version 1.1, April 2024 Heat Pump Control with SolarEdge ONE Smart Home System 1 Heat Pump Control with SolarEdge Home Load Controller — Application Note This Application Note describes how the Home Load Controller transforms a heat pump into thermal storage for excess solar energy and preserves battery life during a power outage. Revision history Version 1.1, April 2024: Included the Home Load…
Application Note - Negative Power Values Displayed in SetApp If you have a StorEdge system installed, a negative power value may be displayed in the SetApp application, in the Status screen. For example: This only happens when your StorEdge inverter charges the battery from the AC grid, and not from PV modules, as it normally does. In this case AC power from the gird is converted into DC power,…
1 Application Note - SolarEdge Three Phase Home Backup Interface Commissioning With SetApp Version 2.xx Version History • Version 2 (July 2023) – Change in Figure 1 • Version 1 (June 2023) - Initial release Introduction The SolarEdge Home Backup solution provides backup power during grid outages. When a power outage occurs, the SolarEdge Backup Interface, Three Phase (BUI) detects the grid…