1 HANDLING AND SAFETY INSTRUCTIONS Version 1.3, April 2020 Safety Information WARNING! Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could result in injury or loss of life. Do not proceed beyond a warning note until the indicated conditions are fully understood and met. CAUTION! Denotes a hazard. It calls attention to a procedure that, if not…
Replacing Safety Switch Fuses with Terminal Blocks in Three Phase Inverters This document describes how to replace the DC fuses in the Safety Switch with DC terminal blocks. The supplied DC terminal blocks support cables with 2-8 AWG cross section. Kit Contents The kit is supplied with replacement parts for 5 inverters: Five (5) pairs of terminal blocks (labeled DC+ and DC-) Five (5) pairs of red…
NOTE For maximum range, make sure to position the antenna upright. NOTE This option is only applicable for StorEdge Single Phase Inverters. ZigBee/Wi-Fi Antenna Installation Kit Contents Antenna with the attached clip and cable Safety Information Please review the following safety guidelines, and observe them when handling the equipment. Always power down the inverter before opening the unit.…
1 Communication Board Replacement in Three Phase Inverters Kit Contents Communication board Required Tools 5mm hex key Torque Philips screwdriver 3mm flat screwdriver Removing the Inverter Cover If the inverter cover is not already removed, use the following procedure for cover removal. To remove the inverter cover 1. Turn the inverter ON/OFF/P switch to OFF. Wait 5 minutes for the capacitors to…