Three Phase Inverter with SetApp Configuration Quick Installation Guide For North America Version 1.0 SAVE THESE INSTRUCTIONS – This manual contains important instructions for the Three Phase Inverter that shall be followed during installation and maintenance. 1. Turn ON/OFF/P Switch to OFF (0) 2. Turn Safety Switch to OFF 3. Open cover screws Fasten screws in described order NOTE Turn ON/OFF the…
1 HANDLING AND SAFETY INSTRUCTIONS Version 1.3, April 2020 Safety Information WARNING! Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could result in injury or loss of life. Do not proceed beyond a warning note until the indicated conditions are fully understood and met. CAUTION! Denotes a hazard. It calls attention to a procedure that, if not…
1 Communication Board Replacement in Three Phase Inverters Kit Contents Communication board Required Tools 5mm hex key Torque Philips screwdriver 3mm flat screwdriver Removing the Inverter Cover If the inverter cover is not already removed, use the following procedure for cover removal. To remove the inverter cover 1. Turn the inverter ON/OFF/P switch to OFF. Wait 5 minutes for the capacitors to…
Replacing Safety Switch Fuses with Terminal Blocks in Three Phase Inverters This document describes how to replace the DC fuses in the Safety Switch with DC terminal blocks. The supplied DC terminal blocks support cables with 2-8 AWG cross section. Kit Contents The kit is supplied with replacement parts for 5 inverters: Five (5) pairs of terminal blocks (labeled DC+ and DC-) Five (5) pairs of red…
Installation Guide Three Phase Inverter for North America Version 1.6 April 2025 MAN-01-01253-1.0 Table of Contents Disclaimers ................................................................................................................................. 5 FCC Compliance ........................................................................................................................ 5…
Knowledge Center