Version 1.1, January 2023 1 MAN-01-00826-1.1 DC Surge Protection Device Installation/Replacement in Three Phase Inverters with Synergy Technology DC Surge Protection Device Installation/Replacement in Three Phase Inverters with Synergy Technology P/N: SExxK-xxxxIxxxx NOTE There are two types of DC Surge Protection Device (SPD) mounting systems for Synergy Manager, Horizontal and Vertical mounting…
1 Communication Board Replacement in Three Phase Inverters Kit Contents Communication board Required Tools 5mm hex key Torque Philips screwdriver 3mm flat screwdriver Removing the Inverter Cover If the inverter cover is not already removed, use the following procedure for cover removal. To remove the inverter cover 1. Turn the inverter ON/OFF/P switch to OFF. Wait 5 minutes for the capacitors to…
1 Replacing Synergy Manager Bracket Replacing Synergy Manager Wall Mounting Corrosion Protective Bracket Instructions This manual describes how to replace a wall mounting corrosion protective bracket of Synergy Manager. Figure 1: Three Phase Inverter with Synergy Technology NOTE The Synergy Manager weighs 18 Kg. SolarEdge recommends two people remove the Synergy Manager from the bracket. Kit…
1 HANDLING AND SAFETY INSTRUCTIONS Version 1.3, April 2020 Safety Information WARNING! Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could result in injury or loss of life. Do not proceed beyond a warning note until the indicated conditions are fully understood and met. CAUTION! Denotes a hazard. It calls attention to a procedure that, if not…
ON/OFF/P Switch Replacement in Energy Hub Inverters Kit Contents ON/OFF/P switch with cables Mounting nut Gasket Plastic tie Required Tools 4mm Allen key Knife Pliers Removing the Inverter and Connection Unit Covers 1. Turn off the ON/OFF/P switch. Wait 5 minutes. 2. Turn off the DC switch on the Connection Unit. 3. Turn off AC to the inverter on the main distribution panel. 4. Release the Allen…