1 Communication Board Replacement in Three Phase Inverters Kit Contents Communication board Required Tools 5mm hex key Torque Philips screwdriver 3mm flat screwdriver Removing the Inverter Cover If the inverter cover is not already removed, use the following procedure for cover removal. To remove the inverter cover 1. Turn the inverter ON/OFF/P switch to OFF. Wait 5 minutes for the capacitors to…
Replacing and Upgrading the Communication Board in a Single Phase Inverter with HD-Wave Technology Revision History 1 Introduction 1 Kit Contents 2 Required Equipment 2 Prerequisites 2 Recording Inverter Configuration 2 Main Procedure 2 Removing the Inverter Cover 3 Replacing the Communication Board 4 Commissioning and Configuring the Inverter 5 Support Contact Information 6 Revision History…
Communication Board Replacement in Single Phase Inverters with HD-Wave Technology and SetApp Kit Contents Communication board Required Tools 4mm hex key Phillips screwdriver 3mm flat screwdriver Removing the Inverter Cover If the inverter cover is not already removed, use the following procedure for cover removal. To remove the inverter cover 1. Turn the inverter ON/OFF/P switch to OFF. Wait 5…
1 MAN-01-00137-1.9 ZigBee/Wi-Fi Antenna Installation NOTE For maximum range, make sure to position the antenna upright. NOTE This option is only applicable for StorEdge Single Phase Inverters. 1.8” / 45 mm ZigBee/Wi-Fi Antenna Installation Kit Contents Antenna with the attached clip and cable Safety Information Please review the following safety guidelines, and observe them when handling the…