solaredge.com SolarEdge Home Network Wireless Mesh Network One communication platform for seamless device connection within the SolarEdge Smart Energy Management ecosystem Faster, easier, and cleaner installations* Avoids the hassle of wired infrastructure with wireless connectivity between inverter and system devices Simple plug and play connection Automatic device detection and configuration…
solaredge.com SolarEdge Home Load Controller Model: DCS Optimize energy consumption by controlling appliance usage Controls permanently connected appliances Includes two controlled dry contact switches Switches larger single and three phase loads via an external contactor Wireless connection to the inverter via SolarEdge Home Network Increases savings by maximizing self-consumption through…
1 Communication Board Replacement in Three Phase Inverters Kit Contents Communication board Required Tools 5mm hex key Torque Philips screwdriver 3mm flat screwdriver Removing the Inverter Cover If the inverter cover is not already removed, use the following procedure for cover removal. To remove the inverter cover 1. Turn the inverter ON/OFF/P switch to OFF. Wait 5 minutes for the capacitors to…
1 MAN-01-00137-1.9 ZigBee/Wi-Fi Antenna Installation NOTE For maximum range, make sure to position the antenna upright. NOTE This option is only applicable for StorEdge Single Phase Inverters. 1.8” / 45 mm ZigBee/Wi-Fi Antenna Installation Kit Contents Antenna with the attached clip and cable Safety Information Please review the following safety guidelines, and observe them when handling the…
Temperature Sensor Kit Installation This document describes how to install a SolarEdge PT100 temperature sensor and connect it to the residential water heater and to the SolarEdge Smart Energy Hot Water device. The sensor allows you to measure the water temperature in the water heater. After installing the sensor, you will be able to view the temperature using SolarEdge monitoring platform.…