solaredge.com SolarEdge Home Load Controller Model: DCS Optimize energy consumption by controlling appliance usage Controls permanently connected appliances Includes two controlled dry contact switches Switches larger single and three phase loads via an external contactor Wireless connection to the inverter via SolarEdge Home Network Increases savings by maximizing self-consumption through…
1 HANDLING AND SAFETY INSTRUCTIONS Version 1.3, April 2020 Safety Information WARNING! Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could result in injury or loss of life. Do not proceed beyond a warning note until the indicated conditions are fully understood and met. CAUTION! Denotes a hazard. It calls attention to a procedure that, if not…
1 Communication Board Replacement in Three Phase Inverters Kit Contents Communication board Required Tools 5mm hex key Torque Philips screwdriver 3mm flat screwdriver Removing the Inverter Cover If the inverter cover is not already removed, use the following procedure for cover removal. To remove the inverter cover 1. Turn the inverter ON/OFF/P switch to OFF. Wait 5 minutes for the capacitors to…
SolarEdge Home Wave Inverter Three Phase, for Hong Kong SE10K 12-25 YEAR WARRANTY Specifically designed to work with power optimizers Internet connection through Ethernet or Wireless (Wi-Fi, ZigBee Gateway, Cellular) IP65 – Outdoor and indoor installation Fixed voltage inverter for longer strings Noise level suitable for residential environments – No external fan Superior efficiency (98%) Battery…
Corrosion Protected Mounting Bracket Replacement Kit for Three Phase Inverters This document lists the content of kits prepared for replacing the mounting brackets: in use with an already installed and working inverter. packaged with a new inverter. Kit Contents Brackets included in these kits are designed for use with Three Phase Inverters with a Product Number pattern matching SExK. Where a…
Communication Board Replacement in Three Phase StorEdge Inverters Kit Contents Communication board Required Tools 5mm hex key Phillips screwdriver Removing the Inverter Cover 1. Switch the inverter ON/OFF/P switch to OFF. Wait 5 minutes for the capacitors to discharge. 2. Disconnect the AC to the inverter by turning OFF the circuit breakers on the distribution panel. 3. Open the Allen screws of…