Backup Interface Installation Checklist 1. Installation and Wiring at the Backup Interface 1.1 Check the torque of all the securing bolts for the mounting bracket and conduit holder. ◻ 1.2 Check the torque of all the electrical connections inside the Backup Interface ◻ 1.3 Take a photograph of the Backup Interface connection area (useful for future debugging, if necessary). ◻ 1.4 If required,…
`1 2 B. Install the circuit breaker 3 OFF Main Service Panel 1 5 OFF 2 Main breaker switch applicable for BI-E only OFF 3 17 in*lbs 23 in*lbs 6 A. Power off the system and open the Backup Interface Inverter Circuit Breaker Installation for connecting an additional inverter to the Backup Interface (BI-N and BI-E models) ELECTRICAL SHOCK HAZARD C. Mount the dead front D. Connect an additional…
NOTE For maximum range, make sure to position the antenna upright. NOTE This option is only applicable for StorEdge Single Phase Inverters. ZigBee/Wi-Fi Antenna Installation Kit Contents Antenna with the attached clip and cable Safety Information Please review the following safety guidelines, and observe them when handling the equipment. Always power down the inverter before opening the unit.…
Revision 1.0, November 2020 1 Application Note–Backup Interface Installation Best Practices Application Note–Backup Interface Installation Best Practices Revision History Revision 1.0 - November 2020 Initial release Introduction SolarEdge’s Backup Interface is designed to create a microgrid during power outages by disconnecting the home from the grid. This application note provides information…