ELECTRICAL SHOCK HAZARD E 2 Datasheet Training 1 C. Din rail adapterA. Screws B. Double sided tape Choose one of 3 options displayed below WARNING! Installation is allowed on up to 2000 meters of altitude Safety Information • For indoor use only • Keep children away from the device • DO NOT use with medical or life support equipment • DO NOT use in wet or damp area • DO NOT clean with liquid •…
1 HANDLING AND SAFETY INSTRUCTIONS Version 1.3, April 2020 Safety Information WARNING! Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could result in injury or loss of life. Do not proceed beyond a warning note until the indicated conditions are fully understood and met. CAUTION! Denotes a hazard. It calls attention to a procedure that, if not…
1 Communication Board Replacement in Three Phase Inverters Kit Contents Communication board Required Tools 5mm hex key Torque Philips screwdriver 3mm flat screwdriver Removing the Inverter Cover If the inverter cover is not already removed, use the following procedure for cover removal. To remove the inverter cover 1. Turn the inverter ON/OFF/P switch to OFF. Wait 5 minutes for the capacitors to…
Installation of AC Surge Protection Device in Three Phase Inverters This document describes how to install the AC Surge Protection Device (SPD) in a Three Phase Inverter. Kit Contents 5 AC SPD boards 5 bags with installation parts. Each bag for single Installation in inverter with terminal block support (see Figure 1) 5 bags with installation parts. Each bag for single installation in inverter…