Communication Board Replacement in Single Phase Inverters with HD-Wave Technology and SetApp Kit Contents Communication board Required Tools 4mm hex key Phillips screwdriver 3mm flat screwdriver Removing the Inverter Cover If the inverter cover is not already removed, use the following procedure for cover removal. To remove the inverter cover 1. Turn the inverter ON/OFF/P switch to OFF. Wait 5…
Installation Guide Communication Options Version 1.4 Version 1.4 November 2023 1 Revision History Version 1.4 (November 2023) Removed regions (heading- Chapter 5) Version 1.2 (February 2018) Changed SolarEdge Logger to Non-SolarEdge Logger in figure 'multiple inverters, RS485 bus, RS485-E, wired Ethernet (LAN) , non SE logger and modified procedure in SE Inverters Configuration after the…
OFF ENET-HBNP-01 1 2 3 4 5 6 5MIN 1. Instale a antena 1 2 1 1 2 2 2. Instale e conecte o conector (pode ser necessário substituir a placa de comunicação) 4 Para evitar choque elétrico, consulte as instruções de segurança no guia de instalação do inversor antes de remover a tampa do inversor. Desligue a alimentação CA do inversor no quadro de distribuição principal. Aguarde cinco minutos. Abra a…
SolarEdge Home Network OK OFF AC OFF ENET-HBNP-01 ENET-HBPV3D-01 ENET-HBPJD-01 ENET-HBCL-01 1 2 3 4 5 6 5MIN 1. Install the Antenna Turn off the inverter ON/OFF/P switch and DC safety switch (if applicable). SolarEdge Home Network Plug-in Installation 1 2 1 12 2 2. Install and Connect the Plug-in (may require communication board replacement) 4 ` 3 To avoid electric shock, refer to safety…